Features :
Comes with Retail Box
High visibility LCD display screen
Port for balance plug for up to 8 cell Lipo, LiFe, or Li-Ion batteries
Can be used as Servo tester to test standard and narrow servos.
Port for discharge plug of NiMh/NiCd batteries
Can be used to check the battery voltage of Lithium batteries including Lipo, LiFe, Li-Ion, as well as NiMH and NiCd batteries.
Measure the voltage of both individual cells and full battery voltage, and can also indicate the highest voltage cell, lowest voltage cell, and difference.
Balance Discharge Current: 90mA × 8 Cell(Max@Cell Voltage 4.2v)
Servo Test Frequency: 50Hz, 60Hz, 100Hz, 125Hz, 200Hz, 250Hz, 300Hz,
Battery Voltage Test Precision: 0.001V
Support Battery Type: Can test Li-Po, Li-ion, Li-Fe (2-8S), NiCd, NiMH(4-8S) battery
Specifications: -
Color: Wood Color
Main material: Wooden
Quadcopter Size: 14*14*8cm (L*W*H) (Estimate)
Remote Control Size: 14*8*5cm (L*W*H) (Estimate)
Flying Area: Indoor/Outdoor
Max Flight Time: 15-20 min
Charging Time: 30-40 min
Flight Distance: Below 120m
Frequency: 2.4Ghz
- Connect two CrystalSky & Cendence Intelligent Batteries and charge them in sequence
- Used to mount a CrystalSky monitor to a Mavic or Spark remote controller.
1. Measured in environments without transmission or signal interference, and wind speeds <4 m/s, where the drone has a flight speed of 15 m/s and reserves 20% battery as a
safety buffer for landing.
2. Measured at a temperature of 25°C. As temperature increases, battery cooling time will increase and lengthen downtime.
3. AC surge protection capacity is 40kA (8/20µs waveform), and meets EN/IEC 61643-11 TYPE 2 protection levels. RJ45 surge protection capacity is 1.5ka (8/20µs waveform).
These meet the CATEGORY C protection level of EN/IEC 61643-21. Surge protection capability depends on the capacity and reliability of grounding. To minimize the risk of surges,
please make sure that grounding is done properly during installation.
4. Each DJI Dock has a built-in backup battery that can provide power for 5 hours and ensure the drone can safely return and land in the event of an emergency power outage.
5. Depending on environmental conditions and the frequency of DJI Dock operations, it is recommended that maintenance be conducted every 6 months or less.
6. Takeoff and landing can withstand wind speeds up to 12 m/s.
Tips
1. When using the adapter board, make sure to place it in an appropriate position to avoid short circuits caused by contact between the adapter board and the aircraft arm.
2. If the adapter board is integrated into a payload product, make sure to design a heat dissipation system and a metal shielding cover.
3. If any sparks, smoke, strange smells, or other abnormalities are detected, disconnect the adapter board from the power source immediately.
4. When all three XT30 power ports are used, the total output power should be smaller than the max output power of the aircraft. Make sure to develop payloads within the output specifications.
- Image quality, power and intelligence to meet the needs of professional filmmakers and enterprises around the globe
Compatibility
- Cendence Remote Controller
- Inspire 2 Remote Controller